Couplings
COUPLINGS
Used to join two pipes or tube spigot ends
Designed to be connected to pipes of different materials, or for use with one material only, couplings are used to join two pipes or tube spigot ends.
There are several ranges of couplings available depending on the required dimensions and allowable operating pressures.
Available products
UltraLink multi-materials couplings with very broad tolerance
Available for continuous lengths of pipe with exterior diameters between OD 49 and OD 348 mm
PFA of 16 bar
Angular deflection of approximately 6° per joint (12° between two pipes)
Link GS couplings for ductile iron pipes
Available from DN 40 to DN 100 with a PFA of 40 bar, DN 125 to DN 300 with a PFA of 25 bar, and DN 350 to DN 600 with a PFA of 16 bar
Link GS couplings for ductile iron pipes with a large DN
Available from DN 350 to DN 1000
PFA of 16 bar
Link PE mechanical anchored Couplings for PE
Available from DN 50/OD 63 to DN 300/OD 315
PFA of 16 bar
FixLink anchored cast iron couplings specially designed for use with cast iron pipes
Used to connect two spigot end pipes or a spigot end pipe and a spigot end gate valve
Suitable for congested areas (basements or chambers) as this sleeve takes up very little space and is tightened from only one side to make installation easier
Available from DN 60 to DN 300 with a PFA of 16 bar and in DN 300 with a PFA of 10 bar
FixLink PVC-PE anchoring couplings for PVC or PE tubes
Suitable for both PVC and PE tubes - for joining PE tubes, reinforcement rings are recommended
Available from OD 60 to OD 280, with a PFA of 16 bar
Connection is possible with PE 80 and PE 100, PN 10 and PN 16 tubes